1. Regular vacuum cleaning and regular floor cleaning can keep the floor beautiful and durable.
More attention should be paid to the areas that pass frequently. When cleaning, use special SPC floor cleaning products, as well as cotton mop. You can also clean the floor with warm water mixed with a little soap.
2. Do not use cleaning products containing surfactants or residues.
Using these products will leave a dull film on the floor and may void the warranty. Before using any cleaning product, first test in a small concealed area.
3. Use small upholstery carpets at all entrances and non rubber doormats outside. This will remove dirt and debris from the shoes. Clean carpet and doormat regularly. Don't leave it on the floor for a long time.
4. Do not use ammonia containing products, wax based polishing / cleaning agents, strong acid or alkaline cleaners, chlorine based products, bleaching agents, solvents, etc. Using these products may permanently damage your floor and may void your warranty.
5. Do not roll or slide furniture or appliances on the floor. It may damage the paint surface of the floor. Carefully and safely lift and move the object into place. In order to reduce possible wear and damage, furniture leg pads are recommended under furniture legs. Clean the protector regularly to remove sand particles that may have been embedded.
6. Avoid pets scratching the floor. High heels may cause dents on the floor.
matters needing attention
Do not install flooring on foam mats, carpets or other soft, rough, uneven or uneven surfaces.
Direct exposure to sunlight from large windows and patio doors may cause the floor surface to exceed the product installation temperature limit, and blinds or curtains need to be installed. Rapid temperature change (high temperature in direct sunlight) may cause temporary deformation of the floor in these areas.
It is not recommended to be installed in areas with excessive heat and large temperature difference, such as solarium, sauna, sunshine room or other areas where the temperature cannot be controlled within 18-29 ℃. If installed in these areas, the floor should be glued to the ground to avoid distortion.
